|
Professional Flagpole Lighting. |
|
This is the light
fixture you need the 175 watt fixture is 10" x 9" x 7" and
will light your 25 to 50 ft. pole perfectly. Shipped wired
for 120 volt application. Can be changed for 208, 240 and
277 volt. |
 |
|
Click Photo
|
Click Here for large detail page
 |
|
Many of the web offerings are over priced low voltage units
that simply won't do any more than make your flag barely
visible. If you're going to light
your flag, , , Then Light It. Low voltage lighting is
ok around your walk way and flower beds but falls far short
of reaching 25 to 100 ft in the air with enough power to
illuminate your flag. |
|
|
Order 175 watt Unit For $240 Delivered
|
|
175 Spot light
perfect for flagpoles. |
|
NOTE: Units Wired
For 120 volt, and can be changed to other settings by
electrician. |
|
|
|
|
|
They produce a blue white light
that will illuminate your flag and make it jump off the
pole. Many other fixtures cast a yellow light and will make
your flag look old and yellowed or just don't produce any
more light than a lightening bug. |
|
|
|
A proper outdoor fixture will have a sealed lens
compartment, (be water tight) you are putting it outside and
pointing it almost straight up, right? An exposed bulb
won't last long. Don't be fooled into thinking quality
"flagpole lighting" can be purchased in the low voltage
range. You Will be disappointed. Why would you pay 300 plus
dollars for something that won't do the job? Yes there is a
bit more work in doing it right but you won't be
disappointed. Photo cell, light , wiring and a post to
mount it on all should cost less than most web offerings of
low voltage units. |
Larger poles require specific lighting, this unit is
suitable for poles 50 to 120 ft. 2 lights are recommended.
For poles over 60 ft.Finish
All products are standard with our exclusive Delta Guard
finish, featuring an E-coat epoxy primer and a bronze acrylic powder topcoat. The
acrylic finish is resistant to the degrading effects of the
ultraviolet radiation from the sun and other environmental
factors. This assures you that the products you install
today will look great in the future as well. We are so
confident, we offer a 7-year finish warranty!
Lamps
Uses ED17 envelope lamps. A metal halide version of the
Axial Parabolic fixture is also available with G12-base
tubular lamp.
Ballasts
All fixtures are standard with a high power factor ballast.
The majority of Flood/Area fixtures are supplied with a
multi-volt ballast. In the U.S., the standard ballast
includes 120, 208, 240 and 277 volts; in Canada, the
standard ballast includes 120, 277 and 347 volts (some
wattages are standard with a 120/277V dual-volt ballast).
Labels
UL Listed in U.S. and Canada for wet locations, and
enclosure classified IP54 and/or IP65 per IEC 529 and IEC
598. |
The
optical system for Mini Axial Parabolic Narrow has a smooth
bright reflector that provides a narrower 8º symmetric beam
angle. Optical chambers are sealed to reduce dirt and insect
contamination. The fixture uses ED17 envelope lamps and are
ideal for illuminating tall, narrow subjects such as
flagpoles, steeples, columns and signs. A metal halide
version of the Axial Parabolic fixture is also available
with G12-base tubular lamp.
To Order this Item
CALL 800-637-3002 or
e-mail
Lamp
is 22" x 22" x 10"D
Unit
Cost is $750.00 per light fixture
with
Metal Halide / MH1000 bulb |
|
|
|
|
Also available Pole Mounted Tunnel Lights |
Click
here to see photo |
|

Sold in sets only, Fixtures are 18" long
6" diameter. Fixtures accept 150 watt
flood lamps for up, down, or up and down lighting.
Bulbs not included. (4) |

AF-Tunnel Light
Part #
Based on pole diameter ie= AF-TL7 would be for a 7”
diameter flagpole.
AF-TL
5 $750.00
AF-TL
5.5 $750.00
AF-TL
6 $800.00
AF-TL
7 $800.00
AF-TL
8 $850.00
AF-TL
10 $900.00
AF-TL
12 $900.00
The
pole can also be pre-wired at factory to simplify setup
and mounting all holes are drilled and ready for lights.
Pre
wire no access door $220.00
Pre
wire with access door in pole $400.00
|